ICDesign Lab
← All tools

Basic Analog Circuit Calculator

Explore MOS amplifier building blocks, from common-source stages to folded cascodes. Change the circuit or its small-signal parameters to see the schematic, equations and estimates update immediately.

8 topologies NMOS / PMOS Reduced small-signal models

1Choose a circuit

No Generate step. Topology changes reset parameters; polarity and option changes keep matching values.

Circuit schematic

Updates with configuration

Small-signal amplifier

The full circuit fits the panel. Bias ports are idealized.

Loading schematic…

White background

2Small-signal parameters

Illustrative values, not a bias solution. Defaults are prefilled for exploration. Replace them with values from your intended operating point.

All fields are required. Units are shown beside each input; scientific notation such as 1e-3 is accepted.

Restores illustrative values for the current circuit.

3Small-signal results

Analytical approximations, not transistor-level SPICE accuracy. Frequencies below are in Hz unless labeled otherwise.

Loading the reduced model…

DC gain

— —

Signed V/V; dB uses gain magnitude.

−3 dB bandwidth

—

Relative to the reduced model’s DC magnitude.

Unity-gain frequency

—

Actual |H(j2πf)| = 1 crossing of this reduced model; not the GBW estimate.

Key equations

Device-parameter expressions for this reduced model. ∥ means parallel resistance; long equations can be scrolled horizontally.

Frequency-response details

Transfer function, pole calculation and numerical coefficients. Equations remain visible when parameter inputs are incomplete.

Assumptions & model limits

Before using these estimates

  • These are reduced, linear small-signal approximations around an assumed operating point. Only the poles, zeros and parasitics explicitly represented by the equations are included.
  • All MOS devices are assumed to operate in saturation. Supply voltage, bias currents, headroom, output swing and saturation are not solved or verified here.
  • Body effect is neglected in all eight models. Verify body connections and device operating points separately.
  • Bias voltages and current sources are idealized except for explicitly modeled small-signal resistance. Bias generation, mismatch, noise and large-signal behavior are outside scope.
  • Differential models use the signal and output convention stated in their equations. Common-mode feedback (CMFB), common-mode operating point and CMFB-loop stability are not designed or checked.
  • Use operating-point analysis and transistor-level simulation to validate a real design. This calculator does not claim transistor-level SPICE accuracy.